Ultrafly Radix 3D Competition Aerobatic Airplane with Brushless Motor.
                         For Advanced Modeler/Flyers.

FEATURES: Construction: Depron foam material 0.05" (1.3mm) thick with center spine in fuselage for added durability Trim Scheme: Red, yellow and orange printed on white fuselage and wings-no heavy decals to apply Motor: Ultrafly brushless B/06/12, UFLG1402 Wings: Biplane style with carbon rod struts to reduce weight Motor Mount: Plywood firewall Wheels: Two 1-1/4" (32mm) foam Landing Gear: Carbon rod Canopy: Single clear Aileron Control: Single servo Hardware: Pushrods, heat shrink tubes, fasteners and hook and loop material

INCLUDES: All pre-cut foam sections to construct airplane, canopy, foam wheels pushrods, hardware, illustrated manual, brushless motor

REQUIRES: Radio: 4-channel with micro receiver Servos: 3 micro size (1-aileron, 1-rudder, 1 elevator) Electronic Speed Control: 10A minimum for brushless motors Propeller: 11" Slo-Flyer type Battery Pack: 2S Lithium-Polymer or 3S Lithium-Polymer Battery Charger: Li-Po compatible Building equipment and foam-safe CA glue

SPECS: Wingspan: 28.3" (720mm) Wing Area: 313 sq in (20.2 sq dm) Wing Loading: 2.8oz sq ft (8.6g/sq dm) Flying Weight: 7.8 - 8.1oz (220g - 250g) Length: 30" (760mm) Center of Gravity (CG): 3.3" (85mm) back from leading edge of wing at the fuselage side. Control Throws: Low Rate High Rate Aileron: Exp 50+ Min. 35° 1.4" (35mm) Max. 45° 0.79" (20mm) Rudder: Exp 50+ Min. 30° 0.79" (20mm) Max. 50° 1.2" (30mm) Elevator: Exp 50+ Min. 30° 1.2" (30mm) Max. 50° 1.8" (45mm)