72MHz Futaba 9CHP Super FM Computer Radio with the
R148DF 8 Channel Receiver and four S3151 Digital Servos.
This version has a non-ratcheted throttle and is configured for helicopter use.
FEATURES: Enhancements to all three modes
over the original 9C series include; Glider Mode; In
addition to the Basic offset trim, three new offsets are
offered (launch, thermal and speed) with camber that can be
customized for each Four camber mixes can be set up on one
screen and programmed to any of the variable dials Airplane
Mode; With either selectable switch using channels 5, 7 or 8
fliers can set up a two rate or a three rate GYA gyro system
Air brake is now switch-selectable Helicopter Mode; Throttle
Curve and Pitch Curve now feature a delay for smoother
transition from hover to idle-up and better control Throttle
Hold and Idle-Up can be assigned to any switch that feels
more comfortable to the pilot 18 model memory total with
included CAMpac module All functions are assignable 3
function timer-up/down or to keep track of total flying
time-and can be programmed to any of the switches, the power
switch or the throttle stick Full functionality trainer
system, requires trainer cord, FUTM4415 (not included) One
year limited warranty
Airplane Programmable Features; Heli
Programmable Features; 7 usable programmable mixes plus 3
usable programmable mixes plus Aileron Differential Governor
Mixing Airbrake (w/delayed elevator 5 Point Throttle, Pitch
and Flaperon and Flap Trim Revolution Curves Elevator Flap
Mix Hover-Throttle Mix and Hover- V-Tail and ELEVON Pitch
Mix 4 Programmable Snap Rolls Trim Delay Throttle-Needle
Mixing 3 Idle-Up Conditions Twin Elevators Options
Throttle-Needle Mixing 2nd Channel Aileron Select Gyro
Mixing Offset Mixing Sailplane Programmable Features; 7
usable programmable mixes plus Single/Dual Flap Servos Flap
Aileron/Aileron Flap Elevator Flap Aileron Differential
Butterfly Mixing _ Start (Launch) Preset Speed Preset
INCLUDES: One 9CHFS Transmitter with
frequency flag set and manual Four S3151 Digital Servos,
R148DF Receiver NT8S700B 700mAh Transmitter Battery, NR-4RB
1000mAh Receiver Battery, One 16K CAMpac Module FBC-19B(4)
Tx & Rx Battery Charger, Neck strap On/Off switch 9" (229mm)
servo extension
REQUIRES: Charging transmitter and
receiver packs and installing servos into model
SPECS: Transmitter T9C Super; Operating
System: 2-stick, 9-channel, PCM1024 system Modulation:
FM/PPM or PCM, switchable Power Supply: 9.6V NT8S700B NiCd
battery Current Drain: 280mA
FP-R148DF Receiver Narrow Band: 20kHz
Narrow Band: 20kHz Intermediate Frequency- 1st IF: 10.7MHz
2nd IF: 455kHz Power Requirements: 4.8 to 6.0V (shared with
servos) Current Drain: 14mA Length: 2.19" (55.5mm) Width:
1.00" (25.5mm) Height: 0.89" (22.5mm) Weight: 1.07 oz
(30.4g)
FBC-19B(4) Wall Charger Input: 120V AC
60Hz 7W Output: Tx 9.6V DC 70mA Rx 4.8V DC 100mA
S3151 Digital Servo Speed: 0.21 sec/60
degrees at 4.8V Torque: 43.1 oz/in @ 4.8V Dimensions:
1.59x0.79x1.42 in (40.6x20x36mm) Weight: 1.48oz (42g)
COMMENTS: The 9C Super differs from the
standard 9C in that the Super's glider mode offers three
offsets that can be customized, launch, thermal and speed
with camber. The four camber mixes can be set up on one
screen and programmed to any of the variable dials. The
Airplane mode offers a selectable switch using channels 5, 7
and 8. All can be set up as 2-rate (up or down) or a 3-rate
(up/center/ down) and a gyro gain menu. The airbrake is now
switch selectable. The Heli mode throttle and pitch curve
offer a delay for smoother transition from hover to idle-up.
The throttle hold and idle-up can be asigned to any switch.
12 model memory |
