Ready To Run
                 AquaCraft U-18 Miss Vegas Sport Hydroplane.
             Designed by Jerry Dunlap, 10 time National Champion
                    and a NAMBA and APBA Hall of Famer.

FEATURES: Hull: Constructed of fiberglass and painted, MaxAccess hull design provides wide-open access to all components including hex drive coupler, plywood formers and foam flotation sections provide strength and rigidity Easy-on Cowl Lock System-push forward to release, push backward to lock Engine: .18 cu in (3cc) AquaCraft (made by O.S. Max) HCAG1147, with pull start, glow plug, dual ball bearing-supported crankshaft, two needle rotary carburetor, ABC liner construction, water-cooled head with water pickup in rudder, 2-year limited warranty Header and Tuned Pipe: Natural finish aluminum Radio: AquaCraft (made by Futaba) 2-channel AM pistol grip with steering and throttle trim and reverse, dual rate knob, charge jack, battery indicator and two SX-100 standard servos Radio Box: Molded plastic with rubber seal and waterproof ON/OFF switch Fuel Tank: 6.1oz (180cc) flip top with filter Propeller: FRP (Fiber-Reinforced Plastic) injection molded Y535 two blade, depth and angle adjustable by loosening screw on strut bracket Rudder: Aluminum with water pickup for engine cooling Turn Fin: Stainless steel mounted on right side for high speed right turns, see COMMENTS Wing: Adjustable to control downforce Boat Stand: Assembled plywood with carrying ropes and rubber cushions where boat rests Decals: Hull accents, logos and window detail Warranty: 90 day limited

INCLUDES: AquaCraft U-18 Miss Vegas Sport Hydroplane with 2-ch pistol grip radio, .18 cu in (3cc) Aquacraft engine with header and tuned pipe, display stand, illustrated instruction manual, instruction and engine tuning DVD and decal sheet

REQUIRES: Fuel: 30% nitro content and at least 16% lubricant content Glow Starter and Fuel Bottle Batteries: 12 AA for radio system Building and shore equipment

SPECS: Hull Length: 30" (760mm) Overall Length: 32.25" (819mm) Beam: 13.8" (350mm) Height: 6.5" (165mm) at top of wing Weight: 4.6lb (2086g) Propeller Shaft Diameter: 1/8"

Carburetor Settings: Needle Valve: 2-1/2 turns OUT from fully closed (factory set) High Speed Needle: Open 1/8 turn at a time to find setting where engine barely runs-this is normal during break-in process

COMMENTS: To launch boat, place in water pushing with a forward motion. Do not sit or drop boat onto water surface. Doing so will cause propeller cavitation and boat will not move forward.

This boat is designed to race in a clockwise circuit and can perform right turns at high speed. Left turns MUST be done at a VERY slow speed with plenty of room. Turning left at high speed will flip the boat.

Metal propellers such as the Octura X432, X435 and Y535 can also be used. We do not carry Octura. Contact them at (847) 674-7351. Never use an aftermarket prop without an X or Y designation.